They are all 100 machined on all surfaces stress relieved and shotpeened.
H beam vs i beam connecting rods.
H beam is a stronger design when bending stress is considered davis said.
Depending on the material you would want at least 900 inch of thickness in that area.
This design makes these rods more rigid and able to handle compression forces.
The ohio crankshaft h beam connecting rod is by far our most popular rod.
With an h beam rod you should look at the thickness of the blades.
H beam rods are more difficult to machine so they are often more expensive.
Consequently h beam connecting rods are often recommended for high torque motors that produce a lot of power at low rpm under 6 000 rpm.
H beam connecting rods incorporate two large flat sides with a thin section in the middle.
Ohio crank h beam rods.
All rods use arp 2000 bolts it is designed for durability with a little more material around the bolt.
H beam connecting rods have some additional things you want to look at before you pull the trigger on a set according to norris.